- #Yamaha mg166cx usb manual español driver#
- #Yamaha mg166cx usb manual español windows 10#
- #Yamaha mg166cx usb manual español windows#
Luckily, at this point there was no noticeable distortion yet.
#Yamaha mg166cx usb manual español windows#
This was loud enough for me (the phones dial being set to 1 / the first "notch"), and translated to a gain level at 8 out of 10 "notches" (3 o'clock position) for all my sound cards (which were set to 100% volume in Windows for input as well as output) as well as my XLR microphone. One test recording confirmed that the STEREO OUT USB signal was now as loud as what I heard on my headphones. The monitor level now usually filled up to the 4-6 bottom-most lights (-15 to -6). Once I realized that, it was only a matter of increasing the gain levels for the different input channels and lowering the master stereo slider as well as the phones level knob (and the AUX1 level knob in the SEND MASTER section) accordingly because the signal was now very strong. They should be around the 0 level (5th from the top).
For normal signals it only went up to a strength of about -25 to -30, which is basically the two bottom indicators of a total of twelve. Another clue was the monitor level display on the right side. Turns out that mixers work best with the highest volume levels possible without distortion or constant peaking which does make sense - if you have more data for the signals, you can do more with them in terms of EQ, FX or anything really. I had intentionally kept everything just as low as I could with the channel sliders on the 0 positions because I didn't want the gain settings to distort my signals. The very friendly and competent person on the other end explained to me that the signal strength the mixer was working with from the input all the way to STEREO OUT was simply too low. I tried installing the ASIO4ALL driver, but it didn't appear to make any difference, so I called the technical support hotline.
#Yamaha mg166cx usb manual español windows 10#
The default one that Windows 10 installed when it first detected the mixer somehow resulted in CPU usage skyrocketting due to svchost.exe.
#Yamaha mg166cx usb manual español driver#
This was after installing the YAMAHA Steinberg USB driver from the official Yamaha Professional Audio website, which I strongly recommend.
That should have been the first indication as to what was wrong. In fact, if I used the USB attenuator function (press the PROGRAM dial/button 5x, turn the dial to adjust between -24 to 0 dB and confirm by pressing it once more) to set it to -24 dB, the lowest setting, only then was it as loud as all my other channels. Audacity barely showed any change in the graphs displaying the signal volume (went from a one pixel thick line to an occasionally 2-3 pixel thick line).Īdditionally, the audio that went into the mixer via USB (channel 11/12 on the MG12XU) was considerably louder than all my other channels. When trying to record the sound that was output via USB to my computer (basically STEREO OUT without the master stereo fader), it did arrive, but the volume was really, really low. I recently got my hands on a Yamaha MG12XU audio mixer and dove right into the world of amateur analog audio mixing.Įverything went fine until it came to the USB interface. 7Aug/17 0 Fixing Low Stereo Out Sound Volume For the Yamaha MG12XU / MG16XU / MG20XU Audio Mixer